Heater & Sanitary

The high cost pressures in the tube manufacturing for heating and sanitary requires the use of machinery which guarantee an extremely high availability.

Schwarze-Robitec builds for decades tube bending machines for heating and sanitary.Technically our machines are the most economical solution. They offer the possibility to carry out all steps fully automatic and fully integrated from production to the checking of the components.

We offer machines which can turn and bent tubes of copper coil. Up to 4 tubes can be bent and cut at the same time.

Our tube bending machines for the ranges sanitary and heating enable the automatic bending and cutting of sheets to 90 ° with radii up to approximately 100 mm. Through the above construction of the machine, especially the cutting after bending, the waste can be reduced by up to 30% compared to traditional methods. Through the special control of the pressure die during the compression bending it is possible to reach R = 1D sheets in Ø 54 x 1.6 mm copper.

In the fully automatic operation of our machines reach in tubes with 40 mm diameter, piece rates of up to 6 seconds.

Produkt range 

Here you will find a selection of our products which are particularly suitable for the tasks of your branches:

 

SR CU – Copper bends in large series

SR CU tube bending machines are designed for the production of single copper bends in large series.

Product Max. Output at 450 N/mm2 Max. Output at 750 N/mm2 Max. Modulus in cm3
SR 32 CU 2 x 32,0 x 2,0 - 2,6
SR 60 CU 60,0 x 5,5 - 11,8
SR 80 CU 89,0 x 7,6 - 36,5
SR 100 CU 114,3 x 8,6 - 70,2